Acrylic products and other materials compared to the advantages of obvious advantages, so very popular in the market, in the production of various acrylic products, to master a set of professional and scientific methods, and pay attention to the following aspects to ensure that the acrylic Product quality and performance.
First of all, in order to avoid the acrylic products appear silver crack, to use acrylic pigments (resin), amino paint, and after painting and then polished, you can achieve smooth, beautiful purpose.
Second, but the production of acrylic display and other acrylic products, the use of acrylic sheet may produce static electricity, resulting in dust attached, this time, in the silk screen or paint before the use of suede or stained with 1% soapy soft cloth clean , In order to achieve the effect of cleaning, acrylic products to protect the aesthetic degree.
In addition, the acrylic products on the surface of some minor scratches or less obvious damage treatment, the general use of sandpaper wet grinding, sanding in the sand when the sand to move, sandpaper fineness to gradually increase to more than 600 heads, and finally the use of toothpaste can.
Therefore, high-quality acrylic products need strict production requirements and standards can be achieved. In the purchase of plexiglass display stand materials to the dealer to emphasize the high purity, or buy back the material carving or cutting may be melting phenomenon. Acrylic is the most commonly used wood after carving processing materials, it is easy to be cut and carved, acrylic has a variety of shapes and sizes, relatively speaking, the cost is relatively low. Carved acrylic general use of back carving way, that is, from the front carving, behind the watch, which makes the finished product more three-dimensional.
In the plexiglass display stand back when you first mirror the graphics to be, and the carving speed faster, the power is low. Such as carving power is too high, will appear on the bottom of the uneven stripes, if you want to carve a little deep can try to carve several times. In the case of the back carving on the local color should be carved at the Department of color carved deeper, and then use the flame polished, can be colored. If you do not polish, from the front to see the color will not be uniform. Plexiglass display shelf cutting is relatively easy to cut, such as customer requirements are not high, after cutting can be delivered without the need for flame polishing. Otherwise the use of blowing equipment should be used to improve the quality of the incision. When cutting more than 8mm of acrylic, should replace the large size of the lens. After cleaning, you can use a damp cloth to clean the surface. Coloring can use acrylic paint, other pigments may damage the acrylic finish!
